Hello,I wanted an explanation of the problem of BGP RIB-failure on a default route 0.0.0.0I wanted to know how to solve this problem and what can cause this?Thanks,
Hello,I wanted to configure failover internet between two routers Cisco 3800 Series.Each router is connected to an ISP. I have configured HSRP protocol on my interfaces and my HSRP configuration works well.I want to configure my routers to switch my ...
I have two Cisco Routers 3800 series for my internet traffic (2 ISP).I configure HSRP on the interfaces gigabitethernet and at the main router I put the multilink interface to track.When the connection drops to the main router traffic does not switch...
Hello,I look at my routing table and I have a default route.S* 0.0.0.0/0 [1/0] via adrIPGatewayIn this case what should I do because I have two same route with different administrative distances?Thanks,
Hi Said,I configured my interfaces with HSRP (priority, preempt, etc. ..), but failover works only if the interface is down. I want to configure my router to switch traffic even if my interface is active.Can I use HSRP to failover my internet traffic...