Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi !We tried to start a traceroute from our Mgmt-Station (HP Openview) to one of our Switches (CAT 3512).I see those UDP requests on the switch:y18w: UDP: rcvd src=172.23.112.36(36902), dst=172.16.4.116(33463), length=201y18w: UDP: rcvd src=172.23.11...
Hi !We are receiving a /24 Route from our external BGP-Peer - and we WOULD like to split this external route into 2 /25-subnets and inject it into IBGP.So - IBGP sees two /25 subnets instead of one /24 subnet.Is it possible ??ANY IDEAS ?THX for HELP!...
Hi !is it possible to define logging filters on the real-time logging of the pix firewall ?"logging monitor 4" shows TOO much entries - I`d like to see ONLY entries for specific SRC or DST addresses like the SMART VIEW TRACKER on a Checkpoint Firewal...
Hi !On several routers we found "buffer misses". Could you please tell me to which problem this might lead ?respectively why do these misses occur ?ThxHans
Hi !I did a "tcpdump" on the Firewall-Interface and saw those outgoing packets to the switch - BUT the switch does NOT send back any reply.IP UNREACHABLES is enabled on the VLAN-Interface.I do NOT know why the switch doesn`t react.
Hi !as you said it matches ....anythingBUT every update looks like this:AS AS AS AS AS ...orAS AS ..or AS AS AS .. and so on....so for my understanding the first line drops everything - not only those who have more than 3 entries.or am I confused too...
Hi Mark !I used this manual - but without success !I tried again with dialing in to a console of a C2600 Router - This was fine ! but connecting the modem to the switch - call isn`t processed againI don`t know WHY ?THX A LOT for your helphans
Thanks !but if you specify the following commandstatic (inside,dmz) (inside network) (inside network)traffic is not translated from DMZ to INSIDE butdoes this command make sure that traffic fromINSIDE to DMZ is not translated either?or do I have to s...
