Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone out there run across a good monitoring/reporting tool for the syslog messages generated by a Cisco router?I have Kiwi Syslog Daemon running to collect the syslog messages, but I am looking for something to actually generate a report/graph ...
Will the 2600 Series router support a WIC-1E or WIC-1ENET? I see that the 1700 series does, but can't find it on the 2600. Shouldn't it be on both?Thanks.
I am going to be putting in a 3640 with 3 WIC-1DSU-T1 interfaces. Our provider is going to be installing 3 T1 lines as 1 will not be sufficient. These will be Frame Relay connections all being used strictly for internet access to the provider/ISP. Wh...
I have a Cisco 2621 Router with an access-list:access-list 111 permit udp any anyI am trying to debug to determine what udp traffic is being matched against that access-list.I have tried debug ip udp, debug ip packet 111.I have turned off ip route-ca...
ScottThanks for your input. I contacted the folks at Kiwi to find out if they knew of a product. They turned me on to a product from Sawmill http://www.sawmill.net.It's great!Brian
I ended up answering my own question, but here is the breakdown for everyone else's viewing pleasure:1) Catalyst 4224 running IOS 12.2(2)YC and MGCP with CM 3.2(1) with Analog VIC-2FXO ports connected to PSTN. I have comfort noise and VAD disabled on...
