Hi,Sorry if this is a dumb question, but I want to remove a SPA504G from the UC320W, so I need to load the 'standard' SPA504G's firmware. Will a simple factory reset of the SPA504G allow me access to the SPA504's GUI to load the relevant firmware? As...

I hope this is not a stupid question, but is it possible to configure an SRP547W's FXO/FXS ports to work with an Asterisk server?I'm setting up a small office to use an Asterisk server and I was going to add a SPA3102 Voice Gateway, to allow me to co...

Hi, I need some advice on the best way to set up a UC320W with an SRP547W router.I have the SRP547W successfully connected to the ADSL connection, with ethernet and WLAN from the SRP457 working correctly. The SRP457 is setup as the DHCP server.The SR...

Hi, I need some advice on the best way to set up a UC320W with an SRP547W router. I have the SRP547W successfully connected to the ADSL connection, with ethernet and WLAN from the SRP457 working correctly. The SRP457 is setup as the DHCP server.The ...

Hi,I currently run a UC320 routing both voice and data, with a simple ADSL modem ahead of it - all runs well, with the exception of all too frequent disconnects on the ADSL modem.So I'm considering a SRP547W to replace the ADSL modem. If I use an SRP...