Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the reason for the client delete in the debug below on a WLC 9800? Deleting the client, reason: 135, CO_CLIENT_DELETE_REASON_MN_AP_AUTH_STOP, Client state S_CO_L2_AUTH_IN_PROGRESS Thanks
Hi,I would like to know the right way to configure CAC for a video stream.The following link enables video CAC in GUI steps and voice CAC in CLI steps.http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/consolidated/b_cg74_CO...
Hi,I am testing guest wlan with foreign map feature.I am not able to assign the client an IP address from the subnet mapped under wlan > foreign map (WLC specific subnet)The debugs on the anchor show a DHCP relay been sent from the interface mapped o...
ap(config-if)#anten gain -10.5 ^% Invalid input detected at '^' marker. The command only accepts whole numbers but the configuration guide mentions decimal in the value, such as 1.5 could be entered.http://ww...
Hi Scott,Thanks for replying. I have lag enabled with mgmt interface tagged, other wlans are getting their IP address from their assigned dynamic interfaces. I would like to use foreign maps on the anchor controller for a guest lan and assign IP ad...
Thanks Scott for your support. I was wondering if there was a bug or I was missing something. I tried with two different versions and had the same result. I hope Cisco corrects their reference guide if this is the case.
