Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to access a Cisco Prime 1.3 VA via CLI, but not having any luck. Working with a customer who does not remember the original "admin" user created at setup. I can access the root shell with the root user (have that user info :))I have also tri...
An advantage of naming the VLANs in the Policy Profile and the Flex Profile is simplifying the configuration if you have different VLAN IDs across different sites as you only need a single policy profile. As long as the VLAN name matches between the ...
Capture all of the output from the command "show run-config" and then run that file through the legacy WLC Config Analyzer tool: https://developer.cisco.com/docs/wireless-troubleshooting-tools/wireless-config-analyzer/
This will give a breakdown of e...
You may want to check if Client Balancing is enabled as well, looks like the algorithm has changed for that on FW 29.x from a passive event (only during association time) to an active event (during and post association):https://documentation.meraki.c...
Another option, outside of setting the APs HA primary/secondary wlc is to not allow APs on your physical wlc (old) to join. Go to the security tab and select "ap policies" on the left. Uncheck all boxes (usually MIC auth is the only one checked).
No ...
