Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Reaching out to see if anybody out there might have a memory or two regarding Waas reporting. I am trying to determine if my DICOM sessions are being optimized and find that I cannot believe the data I am seeing in CM. summary: Have a OE7541 waas ...
I have an older ISE environment we have some PSNs that are running at 99% CPU utilization. Wondering how to get them to perform a little better until we rebuild a new environment. Can we just increase CPUs? **Note we are currently building a new ...
Hi folks, I have an issue with getting large show run-config files from my controllers in their entirety. Seems like they end prematurely around 3.3 megs. I am using SecureCRT and the logging feature does not show a limitation for the file sizes. T...
Hello folks, I am putting together a medium to large distributed ISE deployment and wondered if anybody could tell me what the maximum number of PSNs are allowed under this configuration. I was reading thru an older training document with version ...
I have a Jujniper ex4200-48px switch and I have LLDP enabled. My problem is seeing the results in my Cisco Prime and also in the Cisco WLC. I am running code version 7.4.121 on my WLC and 1.3.020 on my CPI. The Cisco docs suggest LLDP support ...
Thanks @alptechexpert , I am finding that CM reports do not breakdown the session enough to let me filter on just my DICOM source IPs. I can see DICOM but I found that I really just need to have a report that says DICOM from source site and these a...
So you are using a Cisco anchor/foreign guest solution, right? We did not see any issues with guests dropping if you change only the guest anchor WLC first. After all everything guest is being sourced from the WLC in your DMZ. Not sure the 1.1.1.1 on...
Are you fielding problems from your virtual being 1.1.1.1? Biggest problem we had was on our WLC anchor guest configuration. That required the reboot and it was not a big deal. But the foreign (the ones at our campuses) we just did them over time wit...
Scott, Are you saying that if youhave 2 WLCs in a RF group or providing access to a building, that you have two different virtual interface IPs? Are they both unique 192.0.x.y? I thought they were supposed to be the same across all controllers i...
