Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I used to have VPDN clients (Using PPTP) which I want to migrate to IPSec VPN Clients using the Cisco VPN Client. Traffic from these users was being translated (NAT) when going out to a site-to-site VPN. This was possibile by setting the VPDN virtu...
There is a ruggedised version of the Access Point, but there is no ruggedised version of the workgroup bridge. Does someone know if it is possibile to use multiple Access Points (around 50) with a single workgroup bridge and have some of the Access ...
Hi All,Just to let you know that after opening a TAC case, I managed to resolve this particular problem.The way to handle these VPN Client connections is to create a loopback interface and set this interface to be "ip nat inside". Then you need to s...
One way around this is to set the inside IP Address using a console cable ... Then go back to using the ASDM on the new IP address. You will probably also need to change the addresses from where you are allowed to manage your ASA.I used to have conf...
