Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am unable to get separate 350 bridges to do etherchannel since upgrading CatOS on 5509. Upgraded software on 5509 from 4.2 to 5.5.5509 connected to 3512 running 12.0 IOS.3512 config Fa0/3 port group 1 distribution destination Fa0/7 port group 1 ...
I have 3 Aironet bridges setup in lab that were pulled from production for intermittent connectivity problems.They seem to work fine until I put a load on them. I have a laptop directly connected to one bridge. The laptop has software that simulates ...
Thanks for the reply. That makes perfect sense. I will try to limit the traffic. The load generator will allow bandwidth limiting.I do get large (30k+) amounts of CRC errors, holdoffs and the queue full discards.Thanks for the advice. Ken
The queue full discards only occur on the non-root bridge. I had 2 bridges that always got the 'queue full discards'. The only bridge that did not get them during testing was the root. So I reconfigured the non-root to root and made the root into non...
Yes it is possible. I do it between Catalyst 5509 and 3548 XL. Works just fine although you cannot telnet to bridges.Apparently this is not a Cisco supported design.Cisco has different solution using routers on either end so that router will load bal...
I had a similar problem.The problem we identified were faulty antennas (Yagi). We replaced the antennas and they work fine now. A couple of our techs had attempted to turn the antennas and popped off the outer cover and ben the actual metal antenna i...
