Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can Any one help me i am trying to configure my Cisco Pix firewall 515e for publishing the web server.My config file is attached.I cannot access the webserver from the internet.Also i have configured the default gateway of the webserver to point it t...
HiCan any one help me on designing my new network.My current network layout is attached on picture 1Currently my network is running on switching only no Vlans are configured. Also in my network i have diffrent switches as mentioned in network layout....
I have a PIX 515e. My company wants to launch the web site which will serve Internet users as well as internal users. In my web server i have two network cards. My firewall has 3 network interface one is inside, other is outside network and the third...
Hi can anyone help me to configure to use dot1x authentication method for my cisco 2960 switch.I am trying to use microsoft IAS as a radius server.i configured certificate cervices also and clients & computers are getting certificates.i configured al...
hiI need some help to configure my network properly. i have layer 3 switch 3750 which is the core switch for my netwrok and other switches some cisco and some 3-com switches 48 ports.no vlans has been configured yet.i am using class c network id for ...
I tried this also but firewall still not accepting this command.i tried to use "any" instead of host, firewall accepted the command but i wasnt able to connect to webserver.also i configured static (dmz,inside) webserver webserver netmask 255.255.255...
Dear husyciscothe static command was accecepted by the firewall but i wasnt able to access the website from internal user, i tried to access with the ip address.both access-list command was not accepted by the firewall and i couldn configure it.it se...
dear husycisco i have change my configuration from conduit command to access-list and it is working fine also.i think before i didnt succed becz the gateway was not configured to web server.now i want to give access to internal users to the web site ...
Dear husyciscoThank you very much for your advise . after putting the default gateway i can access my website from internet.other thing i want to ask u how i can publish the website for internal users. before u suggest me to use static command with a...
HiI tried these commands also but its not working still. Also in syslog i didnt get any error message i rechecked the conectivity of my firewall to internet and its ok. i can use vpn connection from my home.but still i cant access the website.
