Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 T1's in a MLPP bundle. I noticed that 2 of the 3 serial interfaces have "ip load-sharing per-packet" defined. Is the config ignored whenever the serial interfaces are part of a multilink bundle? The multilink interface does not have this ...
I have multiple circuits into a remote site. One of these circuits is a PTP DS3, and the other is a frac DS3 over MPLS. The MPLS connection is running BGP. I have a GRE tunnel configured over the MPLS circuit between 2 - 3845 routers. EIGRP is co...
Is the shaper class of service or DSCP aware? In the below example, policy-map 25Mbs-75_24 is applied outbound to a serial interface. It's a parent child policy where it first shapes to 25Mb and then calls the policy map. How does a voice packet g...
I have a pair of PIX 515E (6.3) running in failover mode. They are currently connecting to a single chassis core. We are upgrading our network with dual 6500's at the core. Is there a way to connect each PIX to a separate core (PIX 1 - Core1, PIX ...
What is the rule when two routing protocols (ex. BGP, OSPF) are running on a router and they both learn about the same route?The route learned from BGP is inserted into the routing table since it has a lower admin distance. Will the route learned fr...
Attached are the brief configs and a diagram. Here is what we are trying to do and why…Site A has an internet connection and is the the default route for site B. Traffic is currently routed over the PTP DS3 where EIGRP is running. We now have co...
I looked at the frag counters on a show ip traffic, and they were not incrementing. The CPU was also below 10%. I will give that a shot though and see if that resolves the issue.Thanks
