Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I have 2 Cisco 1811 routers with the advanced ip svc ios set on it. I currently have it running with everything communicating properly but I need to add another VLAN to each router and cant get it to recognize.. here is the set upR1 Vlan1 is 10...
Hi, My ISP has just given me a second block of IP addresses coming in through my outside interface. I have created a subinterface off the outside and assigned it to a new vlan. When I look at my ADSM log, I can see denied packets hitting the new bloc...
Hi,My ISP has just given me a second block of IP addresses coming in through my outside interface. I have created a subinterface off the outside and assigned it to a new vlan. When I look at my ADSM log, I can see denied packets hitting the new blo...
I have a connection coming in via Fiber with a block of ip addresses given to me. I need to have my PIX setup in transparent mode in order to use these addresses on my internal network and still filter traffic. Is it possible to send the traffic out...
i added the ip nat inside and seems that there is some activity going on... i still cant ping a host on either network from either router.. but then again i cant ping any host from any router on opposite sides.. any insight into that?i have attached ...
