Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can I get an example config of Firewall settings to push to windows clients. Ever since I split the tunnel to only tunnel my network traffic the Windows GPO does not seem to get applied automatically. If I do away with the split tunnel the GPO applie...
I have 5 IP addresses on my back up interface. I would like to test using remote desktop through my back up interface. I set up the security TCP 3389 and the NAT to the box I want test. But I think my routing is going back out my outside interface. I...
Cisco VPN Client 5.0.02.0090Connectiing to ASA5520Using NTAuth to authenticate.The Clients are using Sierra Wireless 595 aircards. Attached is my ASA running config. The tunnel Group PDClient is reporting the intermentent problem. I have also had the...
I am looking to create 2 VLAN's. VLAN 1 will be tunneling through a VPN to our corporate office. VLAN10 will be used for contractors to access the internet. I need help configuring the VLAN trunking, DHCP to supply to both VLAN's. I supplied my runni...
I added the group of PDVCSO to the permit. It is working. I am waiting on my field officers to report back to me. I will let you know the outcome. What difference does should it make forcing all traffic like my original config compaired to only the s...
Now I can access all my network resources. Windows Firewall was blocking. Sorry. I also had the subnet mask for allowing access to my 10.8 network. I am going to have to wait on reports from the field if they are continuing to drop.
I did the above and of course it broke some applications going to non 192.168.0.0 /ip's.So I did add example 10.8.0.0/16 to the permit. Now I am unable to use VNC or even ping from 192.168.1.0 Network.From the laptop I can ping 192.168.0.0 network. A...
All entries went in with out a problem. Except the command on the router port connected to the 3550. In this case I am using interface fastethernet0. Switchport mode trunk works but am unable to do the switchport trunk encap dot1q. I can put it in bu...
