Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we will deploy waas in branch with asa so we will make wccp redirect on asa as asa will terminate vpn with headoffice so we must use wccp on asa is there is any document of sample of configuration to configure wccp with asa
had any one try mobile waas i have aquetion if users use proxy to access internet i think the behaviour of the connection that the client will connect to mobilewaas server then any connection to internet will go frist to server then go to proxy , is ...
i tried this configuraion for load balance all tcp traffic to waas in datacenter and it workedACE(config)# class-map match-any ALL-TCPACE(config-cmap)# 10 match virtual-address 0.0.0.0 0.0.0.0 tcp anyACE(config-cmap)# exitACE(config)# policy-map type...
i have issue in a company has GRE tunnels (btween datacenter&branchs)in serial interfaces so I applied wccp 62 in & 61 out in tunnel interface and it couldn't work I noticed that they use MTU 1472 did the tunnel connection has any special configurati...
We using wccp for redirect traffic to waas and 4.0.23 for waas so when we operate waas the users in branch could not join domain "microsoft domain" and when we close WCCP users can successfully join domain so we closed EMP mapper and changed policy i...
another solution but pit complex to do GRE tunnel between A & B then default route on A (through internet connection) and another one on A with higher AD through tunnel
what about switch over btween standby and primary is that manual (should i manual force standby to be primary) or the standby become primary automatic (in case of primary faild).
they don't use MS Outlook in mail so the only problem i faced users can not join domain "for first time" when wccp enabled and i applied no adapter epm enable and still not working.
i use 3 wae 512 for datacenter & branch & c.m 6513 in datacenter & 2800 in branchs and tunnel source serial on 6500 and tunnel destenation serial of branch.in datacenter: i configured 62 in & 61 out tunnel interfacein branch 61 in users subinterface ...
