Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 9500 (cisco C9500-24Y4C (X86)) and am trying to configure a 25 Gig port as a SPAN destination.All the documentation I read says - say I am configuring interface Twe1/0/4conf tinterface Twe1/0/4switchportswitchport monitorBut the interf...
We have a POS 155 Mbps circuit.There are tail drops occurring on the default class which is allocated 25% (38.75 Mbps). There is some voice traffic but that is priority queued and is not a problem. Other control classes also OK.But when I look at the...
No luck there....correct me if I'm wrongrouter#conf tEnter configuration commands, one per line. End with CNTL/Z.router(config)#int Twe1/0/4router(config-if)#monitor ?% Unrecognized commandIf you meant globallyrouter(config)#monitor capture ?% Unreco...
This is the problem - not the VLANs or the monitor session.router#conf tEnter configuration commands, one per line. End with CNTL/Z.router(config)#int Twe1/0/4router(config-if)#switchportrouter(config-if)#switchport monitor^% Invalid input detected a...
