Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
uration:
we are planning to migrate from nortel to cisco but having problem in configuring vlan ports from nortel to cisco.
Please help in this.
Config:
vlan ports 1-46 tagging unTagAll filter-untagged-frame disable filter-unregist ----More (q=Q...
Hello All,
I do not see any documentation mentioned that C3850-NM-2-10G supports GLC-SX-MM/ GLC-SX-MMD and GLC-LH-SM/GLC-LH-SMD SFP transceivers. Plesae let me know if it supports or not.
Thanks,
Prashirsha
Hello,
Please help me to get the answers on below query.
1-VSS configuration for 4506E switch
2-Best practices in Stack of 3850 for uplinks
Regards,
Prashirsha
Hello,
I am having problem in one of the customer. i am getting arp and mac for the customer end vlan but the other end ip is not pinging.
Please help
Connectivity:
SP router >> SP switch >>> media >>>> customer end router
NAGPUR-MSW-01#sh mac addre...
Hi Mark,
Thanks for the reply but in think they both have different queuing size so if there will be high utilization than according to the queuing size the high priority traffic can be send easily in 3850 than 2960.
Please put some more light on thi...
Hi martin,we do not have the access of the customer end. But i have a doubt if there is any access list that might be stopping the packets that should be echo reply. but than the other end ie 203.76.133.86 should also not pinging. why only this ip 20...
Hi Martin,Sorry for the confusion. Please find the output of required command and still drops are facing in self ip.VAPI-PE-01#sh int GigabitEthernet0/0.115 rate-limitGigabitEthernet0/0.115 HDFC- Char Rasta Vapi 512 K VPN 23-12-13 Input matches: ...
Hi Martin,Yes, at that time traffic was very low. the output of rate limit is provided above.======Ouote=== Earlier:VAPI-PE-01#sh run int gi0/0.115Building configuration...Current configuration : 355 bytes!interface GigabitEthernet0/0.115 description...
Hi Peter,Thanks, i will talk to media team regarding this. just need a little bit more info, suppose i am taking vlan id with 2992 it is having drops but when i simply changed it to 2995 . no drops occur. path is same . so does by changingthe simply ...
