Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I fully configured the appliance and, of course, changed the enable password, and then failed to document it, somehow, and I've long since forgotten it. I've looked for a recovery procedure, but haven't found one.Can anyone point me in the right dir...
A client contacted me for assistance with their wireless network. They had just purchased three WAP121 wireless access points and upon setting them up discovered the devices provided extremely slow access to the Internet. They have cable Internet ser...
I am fairly new to the PIX 501 and so this is the first time I have run up against this type of issue. I have installed a PIX 501 for a client with a small network. The firewall has the 10-user license. Not long after that they had an issue where a u...
I have clients running Exchange Server 2003. More than one of them are plagued by (presumably) scripted attempts to log in to their SMTP server, using a long list of common American names. Please forgive what is undoubtedly a basic question--but can ...
I have installed a Cisco PIX 501 at a client's site, and now a couple of weeks later we are having an issue where some computers cannot access the Internet. The PCs can ping the internal interface of the firewall, and can resolve hostnames. But about...
I was informed the units my client purchased were "seed units" never intended for resale. We returned them for a refund. You should do the same or try a warranty exchange.
Thanks Jorge for your help, that is great. Now what I find is that the problem is that I need to exclude from NAT not just the one IP address that gets assigned to the virtual PPP adapter associated with RRAS--I need to exclude an entire range of IP ...
Any chance you can help me make sense of this? Does it really look like we have exceeded the number of allowed connections by over 3400?pixfirewall# show local-hostInterface inside: 10 active, 10 maximum active, 3493 deniedlocal host: <192.168.1.2>, ...
