Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up my access point (Cisco Aironet 1200) by assigning IP address, SM, DG, DNS. I have also setup my Wireless Client LAN adapater card with its own IP Address, SM (Same as access point),DG (Same as access point), DNS (Same as access point). ...
I can not execute the command SHOW RUN. The only parameters for the SHOW command are: aaa Show AAA val auto Show Automation Template call Show call ...
No I can not browse on the wired sidePlease confirm that I do the following:1. Connect the AP to Laptop (Console port)2. Connect using HyperTerminal3. Type on Command prompt: config t ip http server end copy run start
