Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm setting up IPsec remote VPN access and I'm following the below guide.http://www.cisco.com/en/US/docs/security/asa/asa80/getting_started/asa5505/quick/guide/rem_acc.htmlThe only difference is that instead of ticking Cisco VPN client, I select t...
This is likely a very basic question....I've got a new Cisco ASA5505 and I'm trying to see some logs at console level. Currently when I do a sh logging I simply get the below. I was expecting or I have seen on other PIX/ASA's system messages.Any idea...
I can't seem to get incoming traffic pass the implicit outside rule. I've configured the below static route and access-list which I hope means anything source tcp address can get through the outside interface on port 1997 only and the static NAT send...
Ok I stand corrected. I used the ASDM GUI and changed to use interface instead of 192.168.18.5....and it didn't work.I then tried it again but this time I used the CLI and now it works. I can only think that I forgot to press APPLY when using the GUI...
Thanks for that. Yeah 192.168.18.5 is the outside interface address. I've tried the above and I still get the same message when I do show log. There must be something fairly obvious that I'm doing incorrectly. Would the entire config of my ASA help?
