Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Custom built tool to manage our existing CSS boxes wherein we shutdown multiple Services at one single instance without affecting the entire VIP. The reason to do that is because of the following scenario. 10 Servers. Each server has multip...
Trying to implement Source NAT for a vlan 400(subnet 10.1.4.x/24)which contains both the servers & the vips.Servers - Default Gateway is the VLAN 400 INterface on the 6500 (which populates the ace module inside) and not the vlan 400 interface on the ...
We have two 6506 switches with ACE modules. I have configured the ACE modules with thenecessary configuration (converted from the existing CSS)..As of now both the ACE modules have the same configuration.ie.Same contextSame Management Vlan IP address...
Can we map multiple external IP to one internal IP on inside (not port redirection)..but just many to one mapping...Module :- FWSM Firewall Version 3.1(4)
You need to configure the Service Interfaces for the servers again with the new port.lie the below example:-Existing Server config:----------------------------service Test-001_Int1_8080 ip address <> port 8080 protocol tcp keepalive type tcp act...
Thanks for the information. We have ACE module (6506 MSFC) and we tried to use ANM Server 1.2 to manage the GUI/report section. Unfortunately, ANM doesnt work like the ACE Appliance Device Manager causing lot of polling issues, limited features, etc....
We had this same problem. Multiple service policies applied on the interfaces doesnt work properly. You need to configure the NAT policies and the VIP policies under a single Service policy before applying it on the interface.Note:- Cisco recommends ...
We did that recently (after so many struggles with SNAT) from css11501 to ACE (6506 MSFC)...SNAT Issues - Fixed it after cisco suggested to configure SLB, SNAT both under one single policy..Active/Standby Config Sync issues (maybe it is due to the hu...
ICMP replies comes from the servers configured for the vip address. Check the icmp connection status to the servers and if probes configured, check them too..
