Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,I have a little little situation here maybe someone can give me a good ideea how to doit.I have 7 routers that I use for my homelab, what I want is a way to connect to all of them without having to change all the time the console cable fro...
Hi guys,As I'm trying to understand the basic BGP way of working, I have a questiong that I need someones help to answer:If I want to use in my AS as IGP, BGP, and I want all the updates to be sent as source from loopback interfaces, before all the B...
Hello guys,Maybe one of you can help me with the following issue that I'm struggeling with:I have a cisco 2501 and I want to change it's IOS, I have the IOS on my TFTP, I can copy from flash to TFTP the curent IOS, but when I'm trying the way back co...
Hi guys,I have a little situation here, that I'm strugalling for a while with it, maybe someone can help me with:I have router 2610:- I am trying to connect to the console port to it, does not work with any baud rate.- I am connected with the cable f...
Try to stop on the windows side the Firewall it stops a lot of times the pingConsidering that you had put both networks in the eigrp process and the link in between the routers is up, you should not have any problemregardsIvian
Thanks guys for all the answers, Here is thou the solution:1. I took out the NVRAM(circuit) put it in a diffrent router. started the router and then cleared the nvram, normal password recovery via console. Very important for thouse that might have th...