Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a ASA 5585 with single slot (No IPS), Simple network, ASA Outside interface connected to Internet /Wan and Inside interface to LAN , ASA Management 0/0 is connected to LAN Access switch Management VLAN.
I have allowed any any policy for man...
Dear Member, I am using 1242AG as outdoor access point for my design, i have to cover all the building with outdoor access point,I am in need of help to find the distance covered by an 1242AG Outdoor AP. As 1242AG can be used as Bridge and AP. SO i n...
route outside 0.0.0.0 0.0.0.0 (Outside interface connected IP) is configured. Configuring the same for the management interface is not allowed, i.e
(conf)#route management 0.0.0.0 0.0.0.0 (Outside interface connected IP)
Error: cannot add route en...
Thanks Marius,
As you stated "that the traffic is routed via the switch and then to the mgmt0/0 interface" what kind of route should be done? Since when I tried to add the default gateway for the ASA Mgmt0/0 to the L3 Management VLAN Interface of Swi...
thanks sir for kind response, Actullay i am looking a for a rough figure in order to proceed with my design , during installation it will be purley based on the site calamties and as you explained in above.
