Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, sorry if the question is already posted: my scenario:- one wireless lan controller WLC 2504 (software version 7.6.130.0) with 11 AIR-CAP702I-E-K9 joined (the controller can support 15 access point), all works smoothly;- to extend the network...
Hello everyone, I am facing a problem with the configuration of a VLAN betweeen two SG200-26 switches (Firmware Version: 1.4.1.3), hope someone can help to me. My setup is pretty simple: __________ __________| | LAG2...
Hi all, after resetting the switches to default config and reconfigured them in LAG (Trunk mode, 1UP, 100T) now I'm able to ping my router (GE2, Access mode, 100UP) from pc in switch2 (GE4, Access mode, 100UP) and have web access to it. I don't know ...
Hi Brandon, about LACP you have to know that is enabled on both switches. LAG1 is connected to a NAS on VLAN ID1, not used in these VLAN tests.I guess you're right, I will try to restore to default my switches and start configuration from scratch, b...
Hi Brandon, your remark is right, I hadn't no particular reason to keep the ports in trunk mode, so I switched them in Access mode but the test ping returns always a "Destination Host Unreachable". On both switches, the GE23, GE24 and GE26 ports are ...
Hi Eric, I integrated my diagram in the first post with more info. The router is a simple TP-Link device for testing purposes, because at the moment I wish only to verify if it's accessible by a web browser or with ICMP packets, I don't need routing ...
