Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a switch where server are connected and this switch is connected to Core sw(VSS)[T1/1/1,T2/1/1] throught Portchannel(TE1/0/1,1/0/2).I am using LACP for portchannel, native vlan is 1 on both the sw, core is root with priority 0 and access ha...
Hi their,greetings.. I have created a route-map and when i applied on the interface it accepted the command. but when i did show run interface i am not able to see the route-map command on the interface. I have Universal K9 license * WS-C3560X-24 ...
Hi,I am using 1850 AP with internal antenna which has 3dbi gain -2.4ghz and 5dbi gain -5ghz, i cannot find it in ekahau in 8.1.0. So need your help on this. Regards,Prashanth
HI Both are cisco device. Core switch is 4500X and access switch is 2960X. on both side native vlan is 1.With one link its works fine, the moment i connect another link in the port-channel, i will get the error.
I got the answer for it.When i did show sdm prefer, i found that current template had number of IPv4 policy based routing aces: 0 so i issued a command in golbal configuration modesdm pefer routingthis command would required reload...
