Hello,
I am in the process of designing a solution for the Cisco ACI MultiPOD Deployment across two data centers in Active/Active.
In case of any VM which fails over to the other location, it will use the local L3-Out for the outside the fabric c...
Hello All,
We are currently in process for replacing an existing Check Point Firewall with Cisco FTD Appliance. In the current Check Point Setup we are using the Check Point as the Gateway for the Management Subnet ( Manager Appliance in Mgmt Subne...
Hello,
Is it possible to deploy ACI Fabric in Multi-POD with option to utilise local L3-Out (local to POD).
If so, what parameters needs to be configured?
Thanks in advance.
Regards,
Harshal
Hello All,
Has anyone worked with ISE integration with Multiple domain without any form of trust relationship while using DNS of one of the domain?
Company A Domain CompanyA.local
Company B Domain CompanyB.local
DNS configured on ISE ...
Hello,
I am facing an issue for AAA authentication of Nexus switch for AD users via ACS 5.8.
Following is the configuration on Nexus:
aaa group server tacacs+ ACS_GRP server 10.2.200.101 use-vrf management source-interface mgmt0aaa authent...
Hello,
The biggest change in the Cisco ACI 3.2 as compared to 3.0/3.1 is the support for the Smart Licensing. Please take a close look at the same before going for an upgrade.
Regards,
Harshal
Hello Gavin,
The most important requirement for deploying ACI in Application Centric Mode is have the detailed Application Dependency Matrix (ADM).
Based on the ADM, servers with the same instance of the Application are grouped together within a ...
Hi,
When you create L3 OUT for connectivity with the Firewall in Active/Standby mode, SVI Based L3 OUT needs to be configured, and regarding the IP Address, please refer to the below example.
Palo Alto Virtual IP 10.0.0.1/24
ACI Leaf 1 Primary ...
Hello Yannick,
Based on the overview given by you, I understand that you do not intend to have any form of L2 Communication between both the DC's (through ACI or Traditional Network).
For such a scenario, you can create Different Fabric Access po...
Hello,
For the Controllers to discover each other, you would have to go ahead with the Fabric Discovery. As the Cluster is formed via the Fabric Interface. And the OOB Interfaces are only there for the Management Connectivity.
Regards,
Harshal