About dwhitefo

dwhitefo · 01-13-2017

Can you provide the configuration for the CUBE? Is the REFER going to another number on CUCM? The output of debug ccsip message would also be helpful.

dwhitefo · 08-11-2014

Try re-installing the CUE software first. If the problem started after a power outage, then it could be a file corruption on the CUE disk. Hopefully, you have a configuration backup somewhere to restore. If you are unable to get the software to re...

dwhitefo · 08-11-2014

The only way to configure this on a SIP to SIP CUBE is with the SUBSCRIBE NOTIFY Passthrough feature which is part of NanoCUBE. http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube_nano/configuration/15-mt/nanocube-config-15-mt-book/voi-nanocu...

dwhitefo · 08-11-2014

I believe the only thing that an extension mobility user can change through the web interface is the speed dials. It do not believe there is a way to change the user password through that interface.

dwhitefo · 08-11-2014

The answer is going to depend on the response from the ITSP when the channels are full. If they are just returning 486 Busy, then no rerouting will occur. Can you capture debug ccsip message from the CUBE to see the responses for a call which is be...

Member Since	‎02-08-2010 11:59 AM
Date Last Visited	‎11-19-2025 07:03 AM
Posts	20
Total Helpful Votes Received	10

User Statistics

User Activity

Can you provide the

Try re-installing the CUE

The only way to configure

I believe the only thing that

The answer is going to depend