Hi all,
Nice answers. Another way to find out whether the ports on a switch are in half or full duplex is using CDP with the command show cdp neighbors detail
Please find below the output. It shows the neighbor duplex operation.
Duplex: full //Neigh...
All VLANs are allowed by default in a trunk link, in your case, you must create the same VLAN on both switches if you're not using a VTP server.Regards.
The authentication you configured was for the interface fa0/0 on Router1.FastEthernet0/0 is up, line protocol is up Internet address is 192.168.0.2/24, Area 1 Process ID 1, Router ID 192.168.0.2, Network Type BROADCAST, Cost: 1 Transmit Delay is 1...
Hi JeffRouter1 and router 2 do not exchange hello packets with Switch1 and the other routers because you have OSPF authentication on Router1 and Router2, You should configure authentication on every device you want to exchange OSPF hello packets, or ...
Hey, Good Morning.Yes, you can open several sessions of TelNet and SSH at the same time. This is because the command "transport input all" comes by default on the device. If you want the device to receive only SSH sessions, use the command "transport...
