Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to enable IP Telephony communication between two different networks(separate networks). but most of the IPs are overlapping for other services. how can I do it.
I am trying to replace my secondary firewall and iam getting error " no response from mate " I can ping the failover interfaces
ASA1---------------failoverfailover lan unit primaryfailover lan interface FOLINK TenGigabitEthernet0/9failover polltime...
We are getting below error on 3850 switch with Ios version 3.6.6E
%ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/1: PD removed%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/1: Power Controller reports power Tstart error detecte...
The link connecting from ASR 9k to 7600 is going to udld error-disable state after connecting few seconds..The physical fiber is fine and we tested the same fiber from another ASR 9k too 7600.
Hi
I am using sfp-10g-lr on asr and x2-10g-lr on 7600 side and I tried with different SFPs and X2s.
Configuration is default on ASR side and this is the configuration on 7600 side.
interface te1/5 switchport switchport trunk encapsulation dot1q sw...
