Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community! I face problem with no possibility to login via Web.Router does not show login page (several browsers tested).Router works, ping is ok.Firmware 1.5.1.11Is it a bug?How to solve it? Thank you.
Hello community! Is there a way how to assign different Easy VPNs to different specific VLANs with Full Channel option for Android Client access?Background:I have several VLANs configured on my RV325.The IP ranges for VPNs is only one for all of conf...
Hello!I have my RV325 Router configured to use Easy VPN connection from outside. My setting for Tunnel mode is Full Channel. Connection from Android mobile works.But it is connected to default VLAN1. When I change Tunnel mode setting to Split channel...
Hello!I have few VLANs, but Router fails to work properly. Devices are connected via Switch cabled with Port 5 to the Routera) either it assigns everything to VLAN 1 if I leave ports of VLAN 1 Untaggedb) or does not assign IP at all if I set Port 5 (...
Hi, thank you for your hint.IP was unique. I was browsing community further on and found this post:https://community.cisco.com/kxiwq67737/board/message?board.id=5951-discussions-small-business-routers&message.id=39344#M39344 It helped.So, I can login...
I activated Restart (reboot) from web interface. After that it was the same = no sccess in Split mode. Btw: I have to say that such reboot took incredibly short time (1 - 2 s) and I did not have to login again. Is it ok or is there something wrong?
I followed that configuration guide. My Android phone says that connection was unsuccessful.0 connection tunnels connected in the Router. Router log is:Dec 17 21:37:58 2020 Name VPN Log: [grpips1][2] xx.xx.4.0/24=== ...yyy.yyy.yyy.yyy===? #34: [Tunne...
Thank you balaji for response.Firmware is 1.5.1.11.EDIT:I found the issue in my Switch connected to Trunk on Port 5.I had there an active DHCP filtering, so it did not accept DHCP for other VLANs (only VLAN 1).after fixing this, the Router and VLANs ...
