Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody, Since some weeks, I have this alert on my Zabbix Server (Like Nagios) for my Cisco ASA : MEMPOOL_HEAPCACHE_0: High memory utilization.This ASA it's only use for VPN client Access.ASA Version : 9.10 Thanks for your help !
Hello,
I need to translate a custom RDP Port. I'm a little bit stuck...
Here the rules :
object network RDP-Server nat (inside,outside) static interface service tcp 3389 33890
access-list outside_access_in extended permit object RDP-Service any ...
Hello all,
I need help to configure my ASA for a specific host.
I have an IPBX and SDSL connection.
I want to send all my traffic of my IPBX server to the interface of my SDSL connection.
MyIPBX -> outside-IPBX (SDSL).
My ASA Version is 9.6.
Yo...
Hello,
I have a little problem, I don't have access to my LAN. I have split-tunnel rules, maybe it's mistake in my NAT rules or another error.
When I'm connected on my VPN, I want to separate the traffic, a route for Google, Facebook etc... And a ro...
ok !
With an internal IP it's OK.
If I use my VPN it's OK.
But, We have a external ressource to help us on the ERP. We prefer a RDP connection than VPN.
What did you mean for tested my port forward ?
I try to connect with a laptop using a 4G, and i have a error. And I'm ok with you, I see the hits on my screenshot after each try.
Hello Daniele,Thanks for your help.
Your command has been accepted by my Cisco Asa. I think it was ok because my Hits are ok.
My Asa Version si 9.6(2)22
You will find in attachment a screenshot of my NAT config with the VPN.
Hello Mohammed,
Thanks for your response. I contacted the TAC, and it's not working. Because, the Next Hop from my SDSL doesn't appear. Maybe I need to upgrade the version.
Actually, I'm stuck.
