Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
atomicgia wrote:Hi i have this situation with a router 877 ios 12.4T:interface vlan 2ip address 192.168.1.0 255.255.255.0interface vlan 1ip address 192.168.0.0 255.255.255.0interface Lo1ip add 10.10.10.0 255.255.255.01)i would like to block any type ...
Hi Steve,Could you post a 'show interface ' of the interface you are having issues with?You asked:Does the switch then immediately discard the packet from the Tx buffer and advance the next one in the buffer to the wire, or does it wait for some kind...
I'd just like to add something to this.An Jon mentioned, the file is in const_nvram:6500-3(config)#do dir const_nvram:Directory of const_nvram:/ 1 -rw- 856 vlan.dat129004 bytes total (128148 bytes free) However, delet...
This sounds like it could be a hit of CSCsv21612.Is VTP pruning enabled. Do you see high SP CPU utilization after the configuration in the PM Callback process? You can view SP CPU utilization with 'remote command switch show process cpu'.This bug is ...
When a frame is ingress on a layer-2 interface on a 4500, the hardware checks the CAM table for both the destination and source ethernet addresses of the frame.In this case, the source address does not exist in CAM, so a source-address-miss interrupt...
