Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,At our Colo center our ISP is giving us two lines. Each going to their own router and are configured as HRSP. I have two firewalls that will be running in HA mode as Active/Passive failover. I need to connect the two lines first to a L2 swi...
Hi all,I have two Cisco ASA 5510s that I would like to configure in an active passive failover setup. The ASAs are at the top of our rack and handle all our routing. We have been only using one ASA unit with one line from our ISP connected to the...
Hi all,I am trying to get MS NLB up and running. It is almost all working. Below is my physical setup.ASA 5510 > Cat 3750X >2x ESXi 5.1 Hosts > vSwitch > Windows 2012 NLB Guest VMs.I have two VMs runing on two different ESXi hosts. They have two v...
Hi all,This is my first VPN configuration I have done with an ASA device. I am trying to setup a remote access VPN using windows L2TP/IPsec. I used the IPsec (IKEv1) Remote Access VPN Wizard in the ASDM to set it up. I have a user in the AAA/Local...
Hi all,I am new to Cisco ASA devices. I have some experience with Catalyst Switches and with the SA smaller security devices. I have a new ASA 5510 and I am trying to use the ASDM GUI software to configure it. I do have a USB to Serial cable thats...
Jon,This was my thinking as well. The cost is not that much of a problem. I'm curious as to what model of switchs I should use for this WAN side switching. I'm use to the Cat serires but obviously dont need many ports. Any recommnedations?Thanks,...
I got it working. I didn't want to put in the investment for adding two routers and two switches in between the ASAs and the ISP. I'm also not sure why I would really need two routers. I got two SG200-08 Smart Switches and setup a vlan for the tra...
Well I fixed it. The issue was with the NLB method. It was set to ICMP-Multicast. I changed it to Multicast and updated the static ARP to the new MAC and everything is fine.
Also If I change to NAT from the public IP to the NLB IP to use either one of the phsyical IPs of the NLB cluster (192.168.0.50 or 51) it works fine when using the public IP. So it's definatly an issue when NATing the VIP of NLB cluster.Chris
