Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Multilayer Switch Feature (WS-F6K-MSFC2) installed in a 6509 chassis.The MSFC hangs periodically where no traffic traverses the switch and from the supervisor I must issue a reset to the device.It will recover after a fashion.It has a redund...
I have an older 2924xl connected to a 3550 switch and on the 2924xl I am getting the following:%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on FastEthernet0/24 (0), with WKF-UNI-SW-A FastEthernet0/18 (200).The 2924 with fa0/24 support...
I have just setup a 3015 VPN server. I am able to connect to the server from a client PC, but, do not see any local lan routes when connected. The secured routes only shows 0.0.0.0 0.0.0.0.I cannot connect to any hosts beyond the 3015.
I have a /29 network defined internal to two 2811's and advertised via BGP.I would like to take two addresses from the /29 and for each permit access from my LAN through a specific tcp port over my WAN and a remote server.i.e.192.168.212.x 389 would ...
Hello, Thanks for your insights and the informative response.I will take this into consideration. Traffic has increased over time through switches and concurrenlty, therre have beentechology upgrades on either side of the 4948's with the upgraded...
Thanks, I managed to get the routes to propagate to the VPN client. I now have a peculiar problem where I am unable to telnet to any remote switch (3550) beyond the 3015. I can ping and trace to the switches (3550's) and routers (2600's) from the co...
