Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have reduced the command privilege as follows: "privilege exec level 1 show startup-config" Now any user with level 1 access can see the startup configuration, but with that he is also able see the snmp community strings in clear text. Enable passw...
Greetings!I have reduced the command privilege as follows:"privilege exec level 1 show startup-config"Now any user with level 1 access can see the startup configuration, but with that he is also able see the snmp community strings in clear text.Enabl...
Greetings!I have given secondary IP addresses to Cisco 7206 series router.The problem is mentioned below:Let us assume the following IP addresses on the Fast Ethernet card:ip address 192.134.200.99 255.255.255.224 secondaryip address 192.134.200.2 25...
Greetings!I am running Dynamic NAT on Cisco 7200 series router.I have a requirement to log the NAT translations with timestamp regularly in order to keep a record of Inside Local to Inside Global IP address allocation.Is there any way to achieve it.P...
Greetings!Here a document whis clearly explains the use of Route-Maps for Natting:http://www.cisco.com/warp/public/105/nat_routemap.htmlThis might help you.Cordially,Anuj
Greetings!Stopbits command means:stopbits 1 Improve throughput by reducing async framing overhead (default is stopbits 2). Transport input command means:To define which protocols to use to connect to a specific line of the router, use the transport i...
