Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please can anyone help with the uploaded topology [ATTACHED with "Type_online-edited"]....it is a life scenario of my case.
I want to have a redundancy between VLANs like if VLAN 100 to PE[Jones] goes down for whatever reason, VLAN 200 to PE[Klee] ca...
Also, the room temperature is ok, power is fine as other devices connected to same source are OK and working, less services...no much routes, few to 20 static routes, two interfaces used, g0/0 from WAN, g0/1 for LAN.very much basic!
I hope this column is still active, i have similar issue, although, the 2911 router just goes blank until a reboot, all interfaces are down. Once rebooted services comes back online.
Below is the display of "show stacks", any help?
show stacksMin...
I think i just might be going for the RSTP,
i want to specially thank you, please dont forget to kindly post any useful link/recommendation on this [RSTP for PW].
This your post has been marked "Correct answer", i appreciate your response and expert...
I am so grateful [@p.dath] but to be honest, all we have presently is the 2950 or 1900 router with of course slot for switch ports, hence we might not be going for option 1.
Then, considering Option 2----RSTP, yes, the book by Moreno cited, actuall...
[@p.dath] , Yes, this is layer2, if they are in different subnet, how will they communicate?, no form of layer 3/routing...whatsoever, from Switch via xconnect to another switch...
Please take a look at this book from Cisco Press in which this exac...