Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm trying to access the CLI of Cisco 1921 through Console Port (cause it's used and I don't know its IP). It only show garbage in the screen and I cannot enter any command. I tried to change the baud rate speed but it only changes the way t...
Hello,
I've had this problem even before where FireSIGHT was indicating this message from a host. I did a full scan to the host with its anti-virus but nothing was captured.
CnC ConnectedIntrusion Event - malware-cnc
Now I'm seeing this message aga...
Hello,
I've seen this alert a couple of weeks ago: "MALWARE-CNC Win.Trojan.Zeus variant outbound connection".
I did a full scan manually on the PC that the alert was pointing and it found nothing.
How can I check if it is a false positive or a true ...
I had this problem several times now during two years I've been working with cisco devices, and I always solved this issue by removing some rules from the Access Control Policy. It has a limited number of rules that if exceeded does not allow the pol...
I finally found the solution, it was the USB-to-Serial cable.
I connected the router into another PC who has Serial (without the USB-to-Serial cable) only with the console cable and it worked perfectly.
Thank you for your replies.
Enid.
1. I tried all of them.
2. I tried it from another PC.
3. I tried another serial cable.
Still the same problem. And I don't understand why the reset doesn't make it work.
Hello Micke,
Thank you so much, I found the results of the scanning and I see only the host's ports if they are filtered or opened but not anything about any possible intrusion.
Enid.
Hello Mike,
Well, I opened a TAC Case and after some lookups they notice something:
The SFR Module is running v5.4.0 however the Defense Center managing it is running v5.4.1.
Also the SFR Module is hitting the following bug: CSCuv99982 - Hardcoded 2...
