I loaded 12.4(19) on a 7206VXR/NPE-300 and it booted fine, but when I did a show version I saw the following message in the output:----------------------------------------This Version of Cisco IOS Software is not supported on NPE300.Please select a v...
Thanks for the input Joseph. I saw the software support ends in versions too, but was curious if anyone was running 12.4 even though it says it isn't supported. I'm going to run with it too until I can get the funds to upgrade.
Have you checked the 'Failed Attempts' under the 'Reports and Activity' button on the ACS server?? The user may be able to authenticate to the router but doesn't have the authorization to go into config mode to create and apply an ACL.
Yes, they will be able to telnet to other devices. If this box is a router, you can deny that user from executing the telnet command via ACS. However, if the box is a UNIX server, there is no way to stop that user from telnetting to other devices. ...
The privilege numbers between 1 and 15 are user definable. You will have to specify the levels in each router that you want this to be enforced on. Then in the ACS server, you can specify a max privilege level on a per user basis or at the group le...
