Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Let's assume we have a traffic flow that starts at the access location, goes thru the distribution router, then thru the core router and terminates at some server in the core. Now if i enable Netflow on the distribution and core routers, and both the...
Hi,1) i do a "show memory" on a cisco 26xx router. It shows me the Total Processor Memory and Total IO memory.When i add up these 2 values, why is it not be equal to total amount of DRAM in your router (as shown by sh ver)???2)Assuming the "sh memor...
Is it possible to use extended ip access-lists for NATing. Basically i want traffic from a particular subnet destined for a particular subnet only to be NATed?? All other traffic should not be NATed. CheersSimon
I have an out-of-the-box Catalyst3548XL switch .There are no user connections nor trunk connections on the switch. But the CPU utilization shows a consistent 50%. Can anybody explain???
Hi,i read the doc u sent me. It was very informative. But what i am interested in is this:Which MIB or OID should i see to get the total amount of DRAM installed in the router?CheersSimon
Hi,I'm sorry ..but it is still not clear....I am not talking about 100% cpu utilization.....For example...the cpu on the router is running at 65% utilization.....that means that the total of the processor utilizations of the individual processes sho...
