Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you change your switch to Cisco 3850 or 3650 then you will be able to use converged access as these switches can also act as mobility controller. Or just get cheap cisco 2504 wireless controller on ebay. You can setup all access points in the same...
I'm using Denali 16.3.7 with converged wireless setup and it seems to be the most stable Denali release so far. It's also cisco recommended version. Note that converged access is not supported beyond Cisco IOS XE Denali 16.3.x
Hope that helps.
Hi Ismail,
LAN Base license allows layer 3 routing by using static routing only. However dynamic routing (OSPF, EIGRP etc) is not supported. If you need dynamic routing then you need IP Base or IP Services license.
More info on different types o...
Spanning Tree is definitely a must have for any good network deployments. It just ensure that you do not create loops when you have redundant paths in your network. I usually enable spanning tree globally and enable portfast on access ports (command ...
Definitely LACP is the way to go. Here is the config you need. This will enable LACP link on the Nexus to both the ESXi Hosts you have. You have to configure ESXi distributed switch with lacp. I have attached the screenshot to message. Please mark h...
