Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have a S2S VPN connected at phase 1, however doesn't successfully negotiate Phase 2. The issue I have is that my Cisco FTD sits behind a NAT device. I have configured NAT-T.My configuration on my FTD has the local peer configured with the pri...
Hi All(Reposting this as I would like to try and achieve an example, using my configuration below, of how I can achieve NAT failover for my Cisco ISR 4431, now I am introducing a new unit for failover)I have a Cisco ISR in live production, and we hav...
Hi AllI have a Cisco ISR in live production, and we have just purchased an additional to run HA for redundancy. I have configured HSRP successfully on the two ISR routers. I have a few SNAT configurations, which I need to ensure work successfully in ...
i All I currently have a twice NAT setup on Cisco ASA 5506 which works perfectly. However we are now implementing a Cisco ISR 4431 to replace the ASA, and wish for this device to perform the twice NAT function like the ASA is currently doing. Here is...
Hi All
We are currently in the process of migrating a number of S2S VPNs from ASA to Firepower. All have been successful, other than one.
The issue with the one that isn't working is the following:
-Tunnel forms both phase 1 and 2
-Traffic traver...
Thanks for your reply. I have been on this option and it gives me the option for "IP Address", which will be the interface IP, which I don't want. And the other two options are FQDN & DN, which I wanted to avoid having to use if I can manipulate the ...
Thanks. I have followed that guide, and drafted my configuration, however the only bit it doesn't let me apply is the redundancy configuration specifically on the interface itself e.g below:redundancy rii 100redundancy group 1 ip 10.14.64.1 exclusive...
I’m not sure this answers the question sorry.This doesn’t address the box-to-box configuration required. I don’t currently have this.I’m looking for someone to confirm what should be amended to the existing configuration.Appreciate your response
Can you provide an example, using my configuration below, on how the configuration should look?interface GigabitEthernet0/0/1description Inside_WVT-RA-VPNip vrf forwarding S2S_VPNip address 10.14.64.253 255.255.255.0ip nat outsidestandby 1 ip 10.14.6...
