Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an IDS 4210 which controls a 2610 Router with two serial interfaces. I have a pre and a post access list for each. With no access-list applied to either interface I enable blocking and the access-list are created on each interface. All is well...
When setting up the IDS it asks for a pre-block and a post-block ACL. I currently have an ACL on my interface; this will be my post-block ACL (correct?). I also have two interfaces in my router; I assume I will add two interface to the IDS? Thanks, H...
All I do with my IDS 4210 is monitor what traffic is doing. I want to start blocking viruses before they enter my network. Is there a way I can set the IDS to only block certain signatures?
I am applying filters directly to my 4210's to limit what I see in Cisco Works MC. After applying the filters I am still receiving the events. Any ideas on what to try? I am entering the filters at IDS Device Manager-> Configuration-> Sensing Engine-...
Sorry, what I ment to say was that I have 2 serial interfaces and 1 ethernet interface. I want to apply the blocking to both serial interfaces, currently I have two ACL's (one for each). So I will need to set up two more on my router as well as on th...
