Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is the NIC in the affected server different than the NICs in the servers that work properly. Some NICs do not support VLAN tagging from the host. You wouldn't see this if the VLAN tag is being added by the switch it is connected to.I think I might ...
Since a switch separates collision domains, you should be fine as long as no individual run (switch port to host, including patch cables) exceeds 100m.
I would consider that it may not be a problem with the Cat, but rather a problem with the browser. Have you recently changed browsers? Have you recently done any updates/security fixes? Many of the latest security updates from MS have changed the ...
Mustafa,Thank you for the clarification, Apparently I misread the original post...I was confused by the fact that I used to list router inventory specifications in that same format (MB/MB) but using DRAM/Flash as the categories. (In fact, it's not u...
You have set a console password, but that does not apply to a telnet session. If I am correct in assuming you want to set a telnet password to the device (layer 3), then you need to do the following:Router(config)#line vty 0 4Router(config-line)#logi...
