Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 4400 wlc that I have been trying to configure but haven be able to access the gui. I have the left the service port with the default ip after I configured it initially configured it through the gui. After wards trying to access the gui...
After I had finished the initial setup I couldn't access the gui from the service port either.I do not have anything configured on the switch no 802.1q trunk, everything is in vlan 1. And the vlan identifier on the wlc is set to 0 for the management ...
