Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cat6509 that is not connected to the network and I am trying to load a software image to it. I start the xmodem transfer and it completes however, I get the following message:loadprog: error - too many ELF program segmentsDoes anyone know w...
When I do the above command I get the folowing:P 0.0.0.0/0, 0 successors, FD is Inaccessible, tag is 325 via 151.131.10.2 (943872/943616), Vlan10What does this mean. The entry is for the default route and the default routs is not installed i...
I have just discovered the same problem. I set up 2 ACS appliances. I was able to replicate from the primary to the secondary with no problems until I rebooted the secondary ACS. Now I cannot connect using http. When I connect to the console and do a...
