Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not sure if this is an ISE or an iPhone issue. ISE 2.2.0.470Patch 2iOS version 10.3.3I have ISE set up to use an Entrust certificate for Portal and EAP Authentication. Native Supplicant Provisioning is set up to issue the profile with ISE Inter...
I'm new to ISE and testing the BYOD onboarding process. I'll log in with an iPhone using AD credentials. Apple's Captive Network Assistant (CNA) will automatically bring up the BYOD portal page. I cancel out of CNA, because the browser is not supp...
It sounds like the AP Manager is not enabled on the Interface that is using Port #2.
Go to Controller > Interfaces
Select the interface with ip 10.0.0.1
It should be using port #2, based on your description.
Click the Enable Dynamic AP Management ...
What happens if you just manually set the primary controller on the AP? (Do you get the same error?)
capwap ap primary-base <wlc name> <wlc ip address>
To make a long story short, a reboot fixed the problem.I think my environment just got jacked up somehow.Long story:I checked the test portal URL and it was showing that is was using the Entrust certificate. The test port URL was an IP address, inst...
I did a step-by-step write up on using ISE as a RADIUS server for device management with AD credentials.Cisco ISE: Device Administration with AD Credentials using RADIUS – WiFi Workshop
Hi hslai,Yes, I'm using two certificates. My thought process was that any certificate presented from the ISE PSNs to ISE Endpoints will be signed by a Certificate Authority that is trusted by almost all devices by default. Also, all ISE Endpoints w...
