Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I'm setting up our UCS for port channeling and i believe we're having switch configuration issues. My supervisor is our interim network guy and isn't too familiar with the LACP protocol. After configuring the switch for LACP and enabling a ...
First off, thank you all for the great community here. It's a wealth of information, always great to see Hopefully someone can help me with my problem; I have been able to find quite a bit of info here to get me, I believe, 95% of the way. I think I...
Hey Keny,Thanks for the reply, I meant to post my resolution for this. First off, this is error I had in addition to a F0399 error which I don't have a screenshot of:Additionally, this is what the Fabric Ports status looked like:Last night during a m...
Hey Atle, when you re-achknowledged the chassis, do you experience any outages? momentary/extended? I have the same error msg and one of the Fabric ports 's "Un Acknowledged" and another is "Un Inititalized". I'd like to re-acknowledge the chassis bu...
We have these two warning messages. The first one I think we can ignore, the second I believe means these ports should no longer be setup for trunk mode?%Warning: portfast should only be enabled on ports connected to a singlehost. Connecting hubs, co...
Hi Padramas!I was able to fix this problem on my own, but that you for the troubleshooting steps. My problem was the target WWN int eh Boot Order Policy was incorrect. I was using the WWPN of the LUN I was trying to boot from. Instead I should have b...
Good morning Padma,On the Blade > Boot Order tab, I see SAN primary as Order 1 and CD-ROM as Order 2. I don't know if that's the actual order.I do, however, see under Blade > Storage I see:fc0, Desired Order =1, Actual Order =5fc1, Desired Order = 2,...
