Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have Site to Site VPN connectivity with one our partner, We are trying to leverage the access more as per the below details 1.) When Remote A users want to access the Remote B servers, at remote A it will be source NATed 2.) When Remote A S...
Hi,
We are trying to establish site to site VPN with one of our partner network we were able to establish VPN connectivity by using only 3DES encryption method when we try to use AES-256 tunnel is not getting established. At our end we are using ASR...
Hi,
In our branch office we had Two MPLS link by different ISPs (both in same ASN For example 100) both the links terminates in our two separate intetnal cisco 2900 routers and we use ebgp to ISP and Ibgp between our internal routers
Both our inter...
Hi All,
In our current setup we are using the DMVPN to establish a connectivity between branch office to the Data Center and we are currently using SHA version 1 and DH group 2. As both the configuration seems to be deemed vulnerable to attack we ar...
I have 4 subnets at remote A10.10.0.0/16 - Server10.20.0.0/16 - Server172.12.0.0/24 - User subnet172.18.0.0/24 - User subnetRemote B subnet :192.0.0.0/16Consider my route and NAT statement at remote A is as follows: Note : Remote A subnet and Remote ...
Thank you very much for your reply.
I have few questions.
Did you mapped any public IP to the Management Interface of both ASAv. And for General Internet access (PAT over interface) how did you configure it.
Is it also through Azure load balancer o...
Smith,
As of now we are using Secondary IP concept to configure multiple Public IP address for various purposes. In case of Active ASAv goes down we are migrating the public IP to back up. This would be very helpful if you share us with the Config ...
