HI.Because the sources are from outsides, and the ports are common ports for attackes, It seems to me more like a "normal" port scan from external hosts, rather then a configuration error at your side.Since these attempts are blocks, I don't think th...
HI.The pix cannot do that (static many>one) using the same port 80.But you have alternate options:* Host both sites on the same ip address.* Configure the proxy with an additional ip address, and provice 2 static mappings, one for each address of the...
HI.You're using PPTP, and the remote WIN2000PRO is the PPTP client, while the pix is acting as PPTP server. Is this correct?If so, then the best solution is to transit to Cisco IPSec VPN with split-tunnel.PPTP does not have this option - you can disa...
HI.I would try the following:> ip verify reverse-path interface dmz Try without the above line - just for the test.> static (dmz,dmz2) DMZ_Network DMZ_Network netmask 255.255.255.224Try to remove that line and add:access-list nonatdmz permit ip 10.21...
HI.I had the same results.On a pix 501 I have upgraded from 6.2(2) to 6.3(1), and from PDM 2.0(2) to 2.1(1) - PDM did not work and poped up a message to install a newer version.I have installed the beta version of PDM 3.0 and it works fine.Yizhar