Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any way to change the display of messages in the spam quarantine interface so the subject line is not truncated? We have some users that don't want to have to mouse over to see the full subject line for each message.
'm using the ASA for anyconnect users and I keep seeing log messages similar to the following: 4 date=Oct 07 2009 Source IP=10.1.1.201 Source Port=17571 Destination IP=10.0.250.18 Destination Port53887 Duplicate TCP SYN from inside:10.1.1.201/17571 t...
I'm using the ASA for anyconnect users and I keep seeing log messages similar to the following:4 date=Oct 07 2009 Source IP=10.1.1.201 Source Port=17571 Destination IP=10.0.250.18 Destination Port53887 Duplicate TCP SYN from inside:10.1.1.201/17571 t...
Is there typically something that has to be done to enable a trunk when being done across a metro ethernet link? I have two switches that I set up that trunk fine when connected with a crossover but will not trunk when connected over the metro-e. I c...
I'm in the process of configuring radius authentication on our 6509 catos switches and I'm a bit confused. When you connect to the msfc using a 'session 15' command what line is it using? I thought that it would be the console line but changes to tha...
the primary reason that I put the switches in place was that between the core isp switches and the firewalls there are a pair of idp's that while transparent have a bad habit of occasionally interfering with the vrrp multicast traffic between the fir...
An application layer firewall will usually look much deeper into the packet than a simple access list will. For example a properly configured application layer firewall may filter out traffic masqurading as legitimate traffic by use of a well known p...
I have ipsec over UDP port enabled, Interesting that the article points to Configuration > User Management > Groups.| Ipsec Tab I find in actually it under the client config tab. I tried the Global Nat-t over tcp but I can't seem to get connected usi...
Ahh this makes a lot more sense to me. so the following should work. I'm assuming that you thought the change to an overload statement instead of a pool would work ok as well. !!establish source translation using the !!route-map ip nat inside source...
