Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently installed a 3550-12T switch (10 x 10/100/1000Base-T + 2 GBIC slots) and installed 2 new 3com 10/100/1000 NIC cards onto two NT4 Servers. We then attempted to get the servers to run at 1000 but were unable to select the option of speed 10...
I have a 3550 switch which is stuck in boot loader mode. When I type as asked "boot" the following is displayed.switch: bootLoading "flash"...flash: permission deniedError loading "flash"Interrupt within 5 seconds to abort boot process.Boot process f...
I have 2 x RSMs on 6509s running HSRP servicing a VLAN on which I'm trying to install two servers acting as cluster ie. same IP address and same MAC 03-xx-xx-xx-xx-xx.access from the LAN is OK , but I'm struggling with WAN access. The routers do not ...
We experienced a slightly similar problem on our 3550. Our port showed down/down but would not come up again until a re-load. We moved the cable to another port and it came up ok. Replacing the cable in its original port proved the same down/down, it...
Thanks for that, yes after doing a dir flash: we can see c3550****.bin,I typed in as boot flash etc the switch will boot up. How do I make it boot without doing this. I.E make it perminant.
easternme, Sorry to tag onto your message but I am experiencing the same problem here with the user refusing to allow the Client to be installed until this has been resolved!!!!!!!
